|
Hardware Supplied:
4 ea. M6 Nyloc® nut,
4 ea. M6 x 30mm screw,
4 ea. 6mm fender washer,
2 ea. Plastic grip bar.
Tools Required:
Philips screwdriver, 10 mm wrench.
Time Required:
Installation takes between 5 and 15 minutes.
Procedures:
The Cargo Cache occupies the entire rack.
It must be placed so that, when the cover is open, it doesn't interfere with the bicycle seat.
- Position the Cargo Cache on the rear bike rack as shown.
- Slide the Cargo Cache rearward so that the cover, when open, just clears the bicycle seat.
- Slide a bolt into a washer; from inside the Cargo cache, slide the bolt into a hole in its bottom
- From beneath the CargoCache, install one of the plastic bars onto the bolt; secure with a nut; do not tighten
- Repeat with the other 3 bolts
- Center the Cargo Cache left-to-right. Slide it front-to-back so that the open cover just clears the seat.
- Using the screwdriver and the wrench, tighten the bolts and nuts. This can take a while, as the nuts are purposely very tight.
- If additional mounting holes are needed, their locations are embossed in the bottom shell.
Download the Installation instructions sheet (pdf)
|
|
